[Serquet70]

So when I am going to RAT someone, I have to put in one of my open ports. The only problem is that I cannot check my open ports. When I go to canyouseeme.org, it cannot see any of my ports. I have tried going into cmd and using the netstat -a command, but none of the ports listed there work with canyouseeme.org. How do I fix this? Also, the IP that is shown on canyouseeme.org is different than the IP that is given to me when I use the ipconfig command in cmd. Please help. I'm a skid.
Thank you!

[Spartan.]

Did you portforward? Also a common mistake is when someone goes to canyouseeme.org and they enter their port, but they don't have that port listening while their RAT is open. So make sure you portforwarded and your RAT is opened with that port listening then go to canyouseeme.org. If all else fails you did portforward and you checked canyouseeme.org then I recommend seeing a RAT spport thread where members will help you out via skype.

[Zink]

Make sure you read the proper tutorials, they will help you.

[Brado]

If you know how to portforward and of its still not works after you have portforwarded.. I recommend to use a Vpn or Vps!