[dat boi]

I am having trouble port forwarding. I am setting up jRAT to use on my other computer in my house so I can have access to it from the computer that I am at. I just need to add the rule the allows that port to become open. My router is very complicated I will post the screenshot of the "add rule" at the end of this thread. Can anyone help me figure this out?

https://imgur.com/JCotf6F

[Ainan007]

Rule Name: Anything
Protocol: UPD/TCP , if it doesnt give u the option to choose both read the Note
Source Ip: Your IPv4
Destination Ip: ^ same thing (I think)
Source port: Port you wanna open
Destination port: Same thing (pretty sure)
Mode: I dunno dafuq (i dont think it matters)
Direction: Inbound (Or outbound idk)

NOTE: IF U CANT DO BOTH AT THE SAME TIME UPD/TCP, MAKE 2 RULES, WITH SAME SETTINGS EXCEPT CHANGE THE PROTOCOL (1 rule with UDP, same rule with TCP)

[dat boi]

Rule Name: Anything
Protocol: UPD/TCP , if it doesnt give u the option to choose both read the Note
Source Ip: Your IPv4
Destination Ip: ^ same thing (I think)
Source port: Port you wanna open
Destination port: Same thing (pretty sure)
Mode: I dunno dafuq (i dont think it matters)
Direction: Inbound (Or outbound idk)

NOTE: IF U CANT DO BOTH AT THE SAME TIME UPD/TCP, MAKE 2 RULES, WITH SAME SETTINGS EXCEPT CHANGE THE PROTOCOL (1 rule with UDP, same rule with TCP)

Didn't work :( It's like my router is so complicated

[Syedboyz]

Mines a bit complicated too LOL

[dat boi]

Mines a bit complicated too LOL

There is literally no way to open up any port on my dusty ass router.