Well i got my NandX FINALLY after like waiting forever on the mail! Well I started to solder it onto my board to pull my nand and flash my DGX Well I ran into an issue on the final wire the solder will not stay on the board it just comes off 😭 Its really iritating btw its the nandX Ground wire. (Yellow)
|
RGH/JTAG
Got my JTAG/RGH Tools and Started my RGH |
 (Apr 21, 2014 08:33 PM)Hexiah Wrote: Just solder it to the AV/HDMI port like you do the coolrunner.. That's what I always do.I need it on the point tho its part of pulling the nand 🤝 I dont use coolrunner at all im using a different chip that is faster.
Apr 21, 2014 08:47 PM
(This post was last modified: Apr 21, 2014 08:47 PM by Hexiah.)
Reading the nand only has to do with the Black, Brown, Orange, Red, Blue and Green wires. I've done this 100s of times.
You can read the nand without even soldering it to the board at all. But it's safer to just solder it to the AV/HDMI port. (Yellow Wire) 
Apr 21, 2014 08:47 PM
(This post was last modified: Apr 21, 2014 08:47 PM by chrispro1994.)
(Apr 21, 2014 08:41 PM)Tyler777 Wrote: I need it on the point tho its part of pulling the nand 🤝 I dont use coolrunner at all im using a different chip that is faster. No ground is ground. It has nothing to do with the nand dump, its just a simple ground. You can solder it to any ground on the board. I Just solder it to the hdd port, just on the metal. That point is always a pain so i gave up trying lol.
Apr 21, 2014 08:50 PM
(This post was last modified: Apr 21, 2014 08:53 PM by Tyler777.)
(Apr 21, 2014 08:47 PM)chrispro1994 Wrote: No ground is ground. It has nothing to do with the nand dump, its just a simple ground. You can solder it to any ground on the board. I Just solder it to the hdd port, just on the metal. That point is always a pain so i gave up trying lol. Well this is all new to me lol I was trying to follow it exactly as it says. but its good to know i can solder it to something else!!! I have not Modded an xbox since you could just buy some wire and reqire it to jtag it 🤝 (Apr 21, 2014 08:49 PM)Doctah Wrote: If it's not sticking then your point is not clean. Apply flux after cleaning it with a qtip and rubbing alcohol. Thanks that would prolly be why i didnt clean it its been so long!😖 |
|
|
