hello mates. I'm actually a newbie to the hacker community so plz bear with me on this. So I wanna hack a site through cmd and i have a 3g dongle connection in my home. So what i did was type -
ping sitename
and then it showed 3 replies through which i known their ip.
then i opened advanced port scanner and scanned the ip where 6 ports were open and 57 were closed.
then i activated my telnet through both, the services and the status change in control panel. In services i made it automatic and clicked start so that it could run.
Unfortunately when i did the same process again and with the ip and then a dot(for the port) an error named "connection could not be made to port 23. connection failed.
I dont understand this. When i mentioned the port 50 why did it want connection 23 to be established? I disabled my firewall and quickheal as well.
Finally, i went to cmd again and typed ipconfig.
Shockingly, my defauly gateway mentions 0.0.0.0. do u think here's the problem? If it is, how should i solve it and if not, plz tell me wheres the problem going? Thank you very much.
ping sitename
and then it showed 3 replies through which i known their ip.
then i opened advanced port scanner and scanned the ip where 6 ports were open and 57 were closed.
then i activated my telnet through both, the services and the status change in control panel. In services i made it automatic and clicked start so that it could run.
Unfortunately when i did the same process again and with the ip and then a dot(for the port) an error named "connection could not be made to port 23. connection failed.
I dont understand this. When i mentioned the port 50 why did it want connection 23 to be established? I disabled my firewall and quickheal as well.
Finally, i went to cmd again and typed ipconfig.
Shockingly, my defauly gateway mentions 0.0.0.0. do u think here's the problem? If it is, how should i solve it and if not, plz tell me wheres the problem going? Thank you very much.