[Refleckz]

My computer freezing and never goes past windows logo screen

[ｋａ＄ｈ]

You should try and access safe mode to begin with, this could just be the result of a corrupt graphic driver or something similar.

You have two main options to access safe mode:
a) if you have a Windows 10 bootable USB then you can set it to boot to safe mode through a command prompt.
b) You can interrupt the boot sequence three times in a row i.e. turn on your PC and immediately turn it off with the power button and this will force it into repair mode.

[Phlox]

Please boot your computer with Windows Setup Media and from Windows Recovery Environment start the Command Prompt.

Please type below command into Command Prompt and press Enter key.

Following command will fixes errors on the disk and locates bad sectors and recovers readable information.

Code

Chkdsk D: /r

Please replace partition letter D: with Windows installed partition letter. When computer boots into Windows Recovery Environment (WinRE) environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 and 10 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition.