[Brebro]

Hello, I am wanting to use either njrat or quasar for my own computers that I have.
The first question that I have is where does one get njrat? I've looked at multiple githubs but don't know where the original one is.
Since I have not been able to find njrat I've been trying to use Quasar. I can make it work if I go through multiple steps of a vpn and no-ip but I would like to not have to do that since 1. I am only going to be using it on my own machines and 2. It is tedious to setup the vpn and no-ip every time I want to get onto my computers. I've been told to use teamviewer or anydesk but I would like to know if anyone is using my pc so a keylogger would be helpful.

TLDR: where can I get njrat and how do I make quasar work without vpn.

[Snoopy]

If you're just setting it up for your own machine then just set it to your localhost (127.0.01) instead of your no-ip host.

[Brebro]

Other machines. I know I can do that but like my grandparents house I have a laptop setup there.

[SIM-4062753]

you can download the original njrat from Dev-Point because the developer used to put it there

good luck

[naxster]

I downloaded my Njrat from here: njRAT v0.7d By njq8 | Download | Connect Trojan

After reading and searching many people have said that this a clean version...
But heey what do I know :P

If anyone could confirm it's clean, it would be great :)

[Brebro]

Another question. Could I use a upnp to connect quasar? Right now I'm trying to figure out "Albertino port mapper" and set it up but so far I've had no luck. I am using canyouseeme(dot)org and it shows the port as open but quasar can't seem to find the client.

---

Figured out what I was doing. Thanks everyone for the help!

[Jacque Fresco]

take a look here https://hackforums.net/showthread.php?tid=5904476