[741398]

Hello all,

This will be my first post here!

I was hoping if someone could shine some light on why my bot's disconnect after they restart their computers? The do not reconnect when they boot up either.

My best guess is, the bot doesn't have my stub installed. How will I get the stub to install?

[PureCoder]

Hello all,

This will be my first post here!

I was hoping if someone could shine some light on why my bot's disconnect after they restart their computers? The do not reconnect when they boot up either.

My best guess is, the bot doesn't have my stub installed. How will I get the stub to install?

On the builder you need to check the startup\install option.

[Elijah]

like pure said you need to enable start-up from the crypter

[SuperiorUser]

a good rule to go off of is to disable all additional features in the builder and enable them in your crypter of choice.

[nCuX0]

Hello all,

This will be my first post here!

I was hoping if someone could shine some light on why my bot's disconnect after they restart their computers? The do not reconnect when they boot up either.

My best guess is, the bot doesn't have my stub installed. How will I get the stub to install?

You should do some tests on virtual machine. make sure you enabled startup within the crypter and check after reboot if it works.
startup method might be also detected, or your file might be runtime detected, in that case you might get another crypter/rat

[Ranker]

Hello all,

This will be my first post here!

I was hoping if someone could shine some light on why my bot's disconnect after they restart their computers? The do not reconnect when they boot up either.

My best guess is, the bot doesn't have my stub installed. How will I get the stub to install?

Enable the Install/melt option in your bot builder settings or use some crypter with install options enabled.

Make sure not to use the install options on both (builder & crypter) otherwise it'll create a mess and probably mess your victim's machine with BSOD.