Hello, I'm new to this site, and I recently discovered a thread called 'Ultimate RAT Collection by Cryakl.' I downloaded CraxRAT, and it's working, but only when the host/IP is my IPv4 address. If the phone is on a different Wi-Fi network, it doesn't work. I tried to set up a hostname with No-IP.com, but I didn't quite understand what to put in the host/IP section in CraxRAT. I set everything up on No-IP, but I'm not sure what to enter in the host/IP section.
Need Help with CraxRAT Configuration and No-IP Setup |
 (Sep 3, 2024 11:26 AM)Soso7554 Wrote: Hello, I'm new to this site, and I recently discovered a thread called 'Ultimate RAT Collection by Cryakl.' I downloaded CraxRAT, and it's working, but only when the host/IP is my IPv4 address. If the phone is on a different Wi-Fi network, it doesn't work. I tried to set up a hostname with No-IP.com, but I didn't quite understand what to put in the host/IP section in CraxRAT. I set everything up on No-IP, but I'm not sure what to enter in the host/IP section. Well, first step would be to switch from the worst, most hated, most notoriously double-infected RAT known. If you try to hack someone with it, there's little chance of it really working. The reason why it's not working for you is certainly because you used not just your IPv4 address, but your private IPv4 address which is not routable over the public Internet (Beginner hackers really need to learn the importance of networking knowledge). The important things to learn here are Network Address Translation, public vs. private IP v4 ranges, and port forwarding. Port forwarding will require different steps depending on the router that you use, but portforward.com is a good resource. Once you've done that, use your router's public IP address (assuming you have one) and add it to your RAT's configuration.   |
|
|
