Home Upgrade Search Memberlist Extras Hacker Tools Award Goals Help Wiki Contact

Toshiba C660 stuck on Windows 7 Logo

Hey,

I was playing a game on my Toshiba C660 when all of the sudden everything froze and went to a blue screen. On the blue screen it said something about '' dumping physical memory '' orsomething and since then im not able to get past the windows logo. Right now it's doing an Startup Repair but I don't think that will help either. I tried to run both Safe Mode and Safe mode with networking but both getting stuck on C:\Windows\System32\Drivers\aswrvrt.sys.

Is there anything I can do ?

Nasim

P.S. I don't know if this is the right section to post so if its the wrong one please tell me.
Do you have "Last known good configuration" on start up? If not, you could still try safe mode with CMD. From there you can try starting a sytem restore. Type rstrui.exe and press enter. If you don't have any good restore points or those also don't work you can try.

1. sfc /scannow
2. chkdsk /r /f

Hope that helps!
Safe mode with CMD will most likely get stuck too. Like above said try last known configuration if its there otherwise you if you have your windows 7 disk around or can burn a disc on another computer you can run a command prompt from that and run the commands above listed :) pm me if you need more help
(May 3, 2015 01:57 AM)RedIce Wrote:  Do you have "Last known good configuration" on start up? If not, you could still try safe mode with CMD. From there you can try starting a sytem restore. Type rstrui.exe and press enter. If you don't have any good restore points or those also don't work you can try.

1. sfc /scannow
2. chkdsk /r /f

Hope that helps!

I tried to do the rstrui.exe but I don't have an system restore point. When pressing F8 when my laptop is starting I clicked on Repair My Computer and then CMD. I tried to type ''scf /scannow '' When I've done that it says, '' There is a system repair pending which requires reboot to complete. Restart Windows and run SFC again. I tried to just restart my laptop but with no success.. I tried ur second option the '' chkdsk /r /f '' but that one is not working. Same story goes with Last Known Good Configuration..

Is there anything else I can do instead of installing Windows all over again ?

Thanks again for replying !
When computer boots into WinRE environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition. Use the Windows partition you found out with Chkdsk D: /r command replace the D: partition with drive letter assign to Windows partition. Type SFC /SCANNOW /OFFBOOTDIR=D:\ /OFFWINDIR=D:\Windows replace the D: partition with drive letter assign to Windows partition.
(May 4, 2015 05:46 PM)Freebooter Wrote:  When computer boots into WinRE environment the drive letter assign to Windows partition may not be C: drive letter because Windows 7, 8 , 8.1 creates a separate system partition when it's installed from scratch. The system partition contains boot files WinRE assigns the system partition the C: drive letter and the Windows installed partition will be assign any other drive letter usually D: drive letter is assign to Windows installed partition. The Bcdedit /enum | find "osdevice" command can be use to find out the drive letter of the Windows installed partition the output of the Bcdedit command is similar to this osdevice partition=D:. The drive letter after partition= is the drive letter of the Windows partition. Use the Windows partition you found out with Chkdsk D: /r command replace the D: partition with drive letter assign to Windows partition. Type SFC /SCANNOW /OFFBOOTDIR=D:\ /OFFWINDIR=D:\Windows replace the D: partition with drive letter assign to Windows partition.

Thanks for answering.

Right now it's performing an D: scan so let's hope something posetive comes out of it. I will keep you posted. Is it ok we can talk via PM ?
(May 6, 2015 06:41 AM)skillznasim Wrote:  Thanks for answering.

Right now it's performing an D: scan so let's hope something posetive comes out of it. I will keep you posted. Is it ok we can talk via PM ?
Yes you can send me PM if you want.


Possibly Related Threads...
Thread / Author Replies Views Last Post
by TheAllMightyNickOct 21, 2018 04:48 PM 28 1,011 Oct 21, 2018 04:48 PM
Last Post: Edge of Nowhere
by Hogtalare1Oct 18, 2016 12:14 PM 2 168 Oct 18, 2016 12:14 PM
Last Post: Hogtalare1
by Tron40May 28, 2016 01:37 PM 0 85 May 28, 2016 01:37 PM
Last Post: Tron40