[Skidsuper]

I am using a cheiftec 750C powersupply which should have more then enough power. When I swap with my older amd gpu it runs ok. But when I use that gpu and use both 8 and 6 pin it wont boot. There is a click and thats it, wont even go to BIOS.

[DramaKing]

I am using a cheiftec 750C powersupply which should have more then enough power. When I swap with my older amd gpu it runs ok. But when I use that gpu and use both 8 and 6 pin it wont boot. There is a click and thats it, wont even go to BIOS.

That doesn't sound like a power issue. Maybe the 3060 is defective? Or the PSU doesn't like the 6 pin being plugged in, which doesn't sound very likely.

[Moooookie]

Sounds more like a hardware conflict, or resource conflict then an issue with the power supply.

[Biggy_Asian]

This is why you should research if your parts are compatible and upgrade ACCORDINGLY. Its not hard to use fucking google bro.

[SIM-2502833]

Could be a BIOS setting if its set to run on older PCIE versions or you have a riser cable.

[F4tDoinkz]

Sounds to me either a bios issue which I think is unlikely, or a defective GPU which is possible.

[Skidsuper]

Sounds to me either a bios issue which I think is unlikely, or a defective GPU which is possible.

I took it to a repair center, they diagnosed one of the power cable is faulty. After fixing it works fine now. Running small llms and diffusion models. Need upgrade to a better graphics card though.